A novel synthesis of allyl and propargyl selenides in aqueous media promoted by indium

Allylic and propargyl bromides react smoothly with diorganyl diselenides in aqueous media to give allylic and propargyl selenides in moderate to good yields. The reaction need not be carried out in inert atmosphere. The speed is quicker than the same reactions in organic media.     

DETERMINATION OF DEGREE OF CRYSTALLINITY OF NYLON 1212 BY WIDE-ANGLE X-RAY DIFFRACTION

Based on the X-ray scattering intensity theory and using the approximate expression for the atomic scattering factor, the correction factors for three crystalline peaks and an amorphous peak of Nylon 1212 were calculated and the formula of degree of crystallinity of Nylon 1212 was derived by a graphic multipeak resolution method. The degree of crystallinity calculated from the WAXD method is compatible with those obtained by density and calorimetry methods.     

Printed plastic electronics and paperlike displays

Plastic electronic materials and high‐resolution printing methods may be important technologies for new classes of consumer electronic devices that are lightweight, mechanically flexible and bendable, and that can cover large areas at low cost. This article summarizes some of our recent work in this area. It focuses on the materials and patterning techniques that we used to produce plastic active‐matrix backplane circuits for a type of paperlike display. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3327–3334, 2002     

Superabsorbent hydrogel composites

A new cost‐effective approach to enhance gel strength of superabsorbent hydrogels was invented. Superabsorbent hydrogel composites (SHCs) were prepared through an optimized rapid solution polymerization of concentrated partially neutralized acrylic acid in the presence of a crosslinking agent under normal atmospheric conditions. Kaolin was used as an inorganic component in the polymerization process to strengthen the hydrogel products. FT‐IR spectroscopy was used to confirm grafting of acrylic chains on to the surface of kaolin particles. Morphology of the products was studied by scanning electron microscopy (SEM). Compared with the kaolin‐free hydrogel (control), kaolin caused a reduced equilibrium swelling and swelling rate as low as 17–31% and 19–29%, respectively. Kaolin, however, resulted in enhanced gel strength as high as 21–35% compared to the control. Differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA) were used to study thermal properties of the composites. The SHCs exhibited higher thermal stability than the control. Meanwhile, changes in certain thermal transitions reconfirmed the chemical interaction of the acrylic chain with kaolin. These thermostabilized strengthened superabsorbent hydrogels may be considered as good candidates for agricultural application to retain more water under soil pressure. Copyright © 2003 John Wiley & Sons, Ltd.     

Carbon‐based Nanosensors for Salicylate Determination in Pharmaceutical Preparations

Thiourea derivative‐based carbon paste electrode (TUD1‐CPE) was constructed as a potentiometric sensor for the determination of salicylate anion in pharmaceutical formulations, Aspocid® and Aspirin®. The optimized CPE contained 45.5 % graphite, 0.5 % reduced graphene oxide (rGO), 46.0 % nitrophenyl octyl ether (NPOE) plasticizer, 5.0 % TUD1 ionophore, and 3.0 % tridodecylmethyl ammonium chloride as additive. The incorporation of NPOE of high dielectric constant, and rGO in electrode caused better performance of the sensor; Nernstian response of 59.0 mV decade^?1 in the concentration range of 10^?1–10^?5 mole L^?1, a detection limit of 1×10^?5 mole L^?1 in a very short response time of 6 seconds. The prepared sensor showed high selectivity against similar anions (i. e. , benzoate, I^?, SCN^?). Selectivity was confirmed by calculating the formation constant (K_β) using sandwich membrane method, where K_β for TUD1‐salicylate is 10^0.43. Theoretical calculations at DFT‐B3LY/6‐31G** level of theory were performed to find interaction mechanism, Energies of HOMO and LUMO orbitals, non‐linear optical (NLO) properties (the electronic dipole moment (μ), first‐order hyperpolarizability (β), the hyper‐Rayleigh scattering (β_HRS) and the depolarization ratio (DR)), and other global properties; these calculations showed lower values of β and DR, higher value of β_HRS, and the shortest lengths of the four N?H bonds between TUD1 and salicylate which confirm their strong complexation and salicylate‐selectivity. Also, all the studied anion‐TUD1 exhibited relatively high NLO properties, and these results were considered as a preliminary study for investigating new types of NLO bearing materials. The sensors were applied successfully for the determination of salicylate anion in Aspocid® and Aspirin®.     

Theoretical and experimental studies of the electrochemistry of <Emphasis Type="Italic">p</Emphasis>-aminophenol on a golden electrode

The geometric parameters, vibrational frequencies, and thermochemical values of p-quinonimine (p-AQ) and p-aminophenol (p-AP) were computed ab initio (IIF) and by the density functional theory (DFT) method with the 6-31G(d, p) basis set. Cyclic voltammetry with a golden electrode of p-AP solutions in phosphate buffers at pH 7.30 showed that the standard electrode potential of half reaction for p-QI and p-AP was 0.728 V. The standard electrode potentials of half reactions for p-QI and p-AP were calculated using the free energies and solvation energies of p-QI, p-AP, p-benzoquinone (p-BQ), and hydroquinone (p-HQ). The results showed that the standard electrode potential of half reaction for p-QI and p-AP was 0.743 V at the B3LYP/6-31G(d, p) level and 0.755 V at the HF/6-31G(d, p) level. The standard electrode potentials computed at the B3LYP/6-31G(d, p) and HF/6-31G(d, p) levels were close to their experimental values. The article is published in the original.     

Cycloarsanes (AsCF3)n (n = 4, 5) – Precursors for the Highly Reactive Diarsene F3CAs=AsCF3

Tetrakis(trifluoromethyl) cyclotetraarsane (F₃CAs)₄ ( 2 ) was used to repeat the UV initiated [4+2]‐cycloaddition reaction of the diarsene F₃CAs=AsCF₃ ( 1 ) with cyclohexa‐1,3‐diene (CHD) and to isolate single crystals of the cycloadduct 4 for a X‐ray diffraction analysis. 4 crystallizes in the space group and contains the diarsene group in its E‐configuration. 2 was also applied for [2+2]‐cycloaddition reactions of 1 with tBuC≡P and MeC≡CNⁱPr₂, but in contrast to positive results with (F₃CP)₄ the products were too labile for isolation. However, 2 was successfully used at room temperature as precursor for coordinating 1 as π‐donor ligand to the Pd(PPh₃)₂ complex fragment yielding η²‐bis(trifluoromethyl)diarsene‐bis(triphenylphosphane)‐palladium(0) 5 , which was characterized by X‐ray diffraction of single crystals and by spectroscopic investigations (NMR, IR, MS). Attempts to prove the existence of the diarsene 1 , generated by different methods, by spectroscopic studies very probably failed due to its extreme reactivity, not allowing the necessary concentrations for detection. Quantum chemical calculations of the stability of 1 with respect to dimerization, the stability of the [2+2]‐cycloadduct with 1‐di(isopropyl)aminopropyne and the energy difference between 4 and the 2,3‐dimethyl‐1,3‐butadiene cycloadduct of 1 were performed to understand the considerable differences between 1 and the related diphosphene F₃CP=PCF₃.     

In Vitro Determination of Dobesilate in Medicine and Human Urine with Chemiluminescence Detection

A unique flow injection chemiluminescence (CL) method for the determination of calcium dobesilate in pharmaceutical preparations and human urine is presented in this paper. The analytical reagents involved in the CL reaction, luminol and ferricyanide, were both immobilized on an anion-exchange column in an FI system. The CL signal produced by the reaction of luminol with ferricyanide (the reagents had been eluted from the column through sodium phosphate injection) decreased in the presence of dobesilate. The decreased CL intensity was linear to the dobesilate concentration in the range 0.2100.0ngmL^–1. At a flow rate of 2.0mLmin^–1, one analytical cycle can be completed in 1.5min, including sampling and washing, resulting in a throughput of 40 cycles per hour. The proposed method was applied successfully to the determination of dobesilate in pharmaceutical preparations and human urine without any pre-treatment. It was found that, after oral administration, the dobesilate concentration reached its maximum after three hours, and the dobesilate metabolism ratio in 24 hours was 57.1% in the bodies of volunteers.Received September 14, 2002; accepted March 11, 2003 Published online July 16, 2003     

Theoretical and experimental investigation of the effect of proton transfer on the (27)al MAS NMR line shapes of zeolite-adsorbate complexes: an independent measure of solid Acid strength

Assessing the degree of proton transfer from a Br?nsted acid site to one or more adsorbed bases is central to arguments regarding the strength of zeolites and other solid acids. In this regard certain solid-state NMR measurements have been fruitful; for example, some (13)C, (15)N, or (31)P resonances of adsorbed bases are sensitive to protonation, and the (1)H chemical shift of the Br?nsted site itself reflects hydrogen bonding. We modeled theoretically the structures of adsorption complexes of several bases on zeolite HZSM-5, calculated the quadrupole coupling constants (Q(cc)) and asymmetry parameters (eta) for aluminum in these complexes and then in turn simulated the central transitions of their (27)Al MAS NMR spectra. The theoretical line width decreased monotonically with the degree of proton transfer, reflecting structural relaxation around aluminum as the proton was transferred to a base. We verified this experimentally for a series of adsorbed bases by way of single-pulse MAS and triple quantum MQMAS (27)Al NMR. The combined theoretical and experimental approach described here provides a strategy by which (27)Al data can be applied to resolve disputed interpretations of proton transfer based on other evidence.     

Hydrothermal Synthesis of Two New Transition Metal Coordination Polymers with Mixed Ligands

Hydrothermal reactions of 1, 2, 4‐benzenetricarboxylic acid, 1, 10‐phenanthroline and transition metal cations including Zn^II or Co^II, in basified aqueous solution gave rise to two complexes, [Zn₃(btrc)₂(1, 10‐phen)₂(H₂O)₂]_n ( 1 ), and [Co₃(btrc)₂(1, 10‐phen)₂(H₂O)₂]_n ( 2 ) (btrc = 1, 2, 4‐benzenetricarboxylate, and 1, 10‐phen = 1, 10‐phenanthroline). 1 2 crystalize isotypically in the triclinic space group P1¯. The btrc ligand acts as multi‐dentate bridging ligand in both compound 1 and 2 to link up transition metal atoms into lamella networks, which are further attached into three‐dimensional frameworks through complex hydrogen bonding and π‐π interactions. The photoluminescence spectrum for compound 1 has also been studied. The corresponding reaction with Cu²⁺ follows another pathway.